Guru Corporation

G-GROUT MF-8 

 INCEPTION· G- GROUT MF-8 is highly fluid,single component, cementitious grout pre packed .

 

· G-GROUT MF-8 powder  It is manufactured by unique PSD technology to facilitate easy to inject and effective deep fine cracks,pores and voids. It has much finer particle size than other hydraulically setting materials. It is produced in state of art manufacturing plants in a controlled environment resulting in excellent filling quality.

PURPOSE·   G- GROUT MF-8 is suitable for injecting and grouting in rock, soil, concrete and masonry and for filling joints, cracks and holes. ·MF-8 can be used at vertical and horizontal surfaces working. MF-8 is a ready-to-use dry-blend mortar based on cement modified with organic additives, which hardens without shrinkage when mixed with water

BENEFITS ·      G-GROUT MF-8 can be injected with standard cement grouting equipment

 

·      Compatible with most of the admixtures to accelerate / retard the setting time 

·      Supports all portions of structures 

·      Fill up the voids in concrete structure, control or prevent the structure from leakage or weak structures to strengthen 

·      Non-toxic, Non-Hazards 

·      Eco friendly & Cost Effective.

 

TECHNICAL SPECIFICATION

Properties                   G-Grout Value

Consistency                Dry Powder

Colour                          Grey

 METHODS OF USES·    Pre-process:

The substrate must be cleaned down to load bearing grain structure. Before grouting the substrate is to be rinsed until it is saturated excess water will be removed. 
Mixing:

MF-8 should be mixed with a slowly rotating mixer to avoid air pockets. First add 2/3 of the totally required water. After mixing for a short time add the balance of water. It should be mixed for approx. 6 minutes. Plastic consistency for vertical and overhead surfaces: 4 litres of water per 20 kg bag Liquid consistency for injection as per requirement.

PACKAGING G-GROUT MF-8 is available in Bulk Jumbo bags with plastic inner liner. The product is also available in 25 kg plastic line bags.

 

STORAGE G-GROUT MF-8 when stored correctly has an indefinite shelf life. Like cement, it must be protected from contamination and moisture. The product can be stored in bulk in a clean, dry storage silo. Shelf life is at least 12 month in original packaging when stored in dry conditions between 15-25°C, protected from heat, frost and direct sunlight. SAFETY INFORMATION Extensive testing has shown G-GROUT MF-8 to be non-toxic and environmentally benign. No known significant health risks are associated with G-GROUT MF-8 but high con-centrations of dust may cause irritation. It is recommended that suitable protective clothing, gloves and eye/face protection is worn. In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice 

 

Furan Mortar Furan Resin Mortar is widely used for Acid Resistant Bricks Tiles lining works as Bedding Jointing Mortar for Tanks, Floor, Drain, Foundation, Chemical Reaction Vessels, and Neutralization Pit etc. Resistant: It is resistant to Non-Oxidizing Acids, Alkalies, Salt, Solvents, Greases, Detergents and Oils.Carbon Filled Furomor Mortar is to be used to resist hot highly concentrated alkalies, Hydrofluoric Acid, Fluoride Salted etc. Resistant to temperature: 170° C (Max.) Preparation of Mortar: Preparation of Mortar generally consists of Solution Powder. In order to obtain good working consistency, the average mixing ratio is 1 Pbw of Solution 3 pbw of Powder. This ratio will slightly vary depending upon the temperature and working conditions. Prepare small batches of Mortar.