Guru Corporation

Benefits:

• Compatible with most of the admixtures to accelerate / retard the setting time 
• Supports all portions of structures 
• Fill up the voids in concrete structure, control or prevent the structure from leakage or weak structures to strengthen 
• Non-toxic, Non-Hazards 
• Eco friendly & Cost Effective.

• The substrate must be cleaned down to load bearing grain structure. Before grouting the substrate is to be rinsed until it is saturated excess water will be removed. 
• MF-8 should be mixed with a slowly rotating mixer to avoid air pockets. First add 2/3 of the totally required water. After mixing for a short time add the balance of water. It should be mixed for approx. 6 minutes. 
• Plastic consistency for vertical and overhead surfaces: 4 litres of water per 20 kg bag Liquid consistency for injection as per requirement.
• Packaging: G-GROUT MF-8 is available in Bulk Jumbo bags with plastic inner liner. The product is also available in 25 kg plastic line bags.
• Storage: G-GROUT MF-8 when stored correctly has an indefinite shelf life. Like cement, it must be protected from contamination and moisture. The product can be stored in bulk in a clean, dry storage silo. 
• Shelf life is at least 12 month in original packaging when stored in dry conditions between 15-25°C, protected from heat, frost and direct sunlight. 
• Safety Information: Extensive testing has shown G-GROUT MF-8 to be non-toxic and environmentally benign. No known significant health risks are associated with G-GROUT MF-8 but high con-centrations of dust may cause irritation. 
• It is recommended that suitable protective clothing, gloves and eye/face protection is worn. 
• In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice.

Application Areas:

• High performance concrete
• High strength, low permeability concrete
• Industrial flooring
• Water tanks and sumps
• Chemical storage tanks
• Basements and sewerage pipelines
• Refractory mixes etc.
• Petroleum Referineries
• Tunnels

• The substrate must be cleaned down to load bearing grain structure. Before grouting the substrate is to be rinsed until it is saturated excess water will be removed. 
• MF-8 should be mixed with a slowly rotating mixer to avoid air pockets. First add 2/3 of the totally required water. After mixing for a short time add the balance of water. It should be mixed for approx. 6 minutes. 
• Plastic consistency for vertical and overhead surfaces: 4 litres of water per 20 kg bag Liquid consistency for injection as per requirement.
• Packaging: G-GROUT MF-8 is available in Bulk Jumbo bags with plastic inner liner. The product is also available in 25 kg plastic line bags.
• Storage: G-GROUT MF-8 when stored correctly has an indefinite shelf life. Like cement, it must be protected from contamination and moisture. The product can be stored in bulk in a clean, dry storage silo. 
• Shelf life is at least 12 month in original packaging when stored in dry conditions between 15-25°C, protected from heat, frost and direct sunlight. 
• Safety Information: Extensive testing has shown G-GROUT MF-8 to be non-toxic and environmentally benign. No known significant health risks are associated with G-GROUT MF-8 but high con-centrations of dust may cause irritation. 
• It is recommended that suitable protective clothing, gloves and eye/face protection is worn. 
• In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice.